Especially in the thinker code this is needed for software rendering.
Strictly speaking, the software renderer should do the same, but it checks r_dynlight in so many places deep in the logic where the level is not available.
Prompted by 'Hurt' which has > 4000 lights and runs into both performance issues and unpredictable light selection for the limited amount of shadowmap slots.
It wasn't respecting the map's pixel ratio setting. This wouldn't have
been very noticeable with the default pixel ratio of 1.2 but it was
very obvious with 1.8.
# draw upper and lower textures when the back sector does not properly match
# do not draw middle textures on portal lines
# minor optimization to 'is***Portal' functions to avoid memory access in the most common case of no portal being present.
Re-worded error messages which were unprecise or unfitting before (model index below 0 was not acknowledged at all, or grouped together with a "too many models" message).
modelIDs are given a default value of -1.
Important: A MODELDEF's FrameIndex lines can no longer refer to model indices that are beyond the number of models of that MODELDEF entry. There is in fact a check to avoid going beyond the number of an actor's models which would abort program operation at startup, but it never caught any such occurances.
surfaceSkinIDs was two-dimensional and is now a one-dimensional TArray as well, elements are accessed via [Row + Column * NumRows], in this case surfaceIndex + modelIndex * MD3_MAX_SURFACES]
Used TArray.Alloc to make TArrays have the correct size depending on the number of models.
Also removed MAX_MODELS_PER_FRAME.
Edited skinSurfaceIDs access for one-dimensional TArray
Added MD3_MODELS_MIN
To ensure compatibility with mods, all model-related TArrays (four in total) have a minimum size of 4, defined by MD3_MODELS_MIN.
* Changed model-related arrays to TArrays.
* Update models.cpp
Used TArray.Alloc to make TArrays have the correct size depending on the number of models.
surfaceSkinIDs was two-dimensional and is now a one-dimensional TArray as well, it's size is now (models * MD3_MAX_SURFACES)
surfaceSkinIDs was two-dimensional and is now a one-dimensional TArray as well, elements are accessed via [Row + Column * NumRows], in this case sSurfaceIndex + modelIndex * MD3_MAX_SURFACES]
* Edited skinSurfaceIDs access for one-dimensional TArray
* Edited skinSurfaceIDs access for one-dimensional TArray
* Edited skinSurfaceIDs access for one-dimensional TArray
* Changed model-related arrays to TArrays.
Also removed MAX_MODELS_PER_FRAME.
* Used TArray.Alloc to make TArrays have the correct size depending on the number of models.
surfaceSkinIDs was two-dimensional and is now a one-dimensional TArray as well, elements are accessed via [Row + Column * NumRows], in this case surfaceIndex + modelIndex * MD3_MAX_SURFACES]
* Used TArray.Alloc to make TArrays have the correct size depending on the number of models.
surfaceSkinIDs was two-dimensional and is now a one-dimensional TArray as well, elements are accessed via [Row + Column * NumRows], in this case surfaceIndex + modelIndex * MD3_MAX_SURFACES]
* Update models.h
* Edited MAX_MODELS_MD3
* Update models_obj.cpp
- Always allow skyboxes by default
- Add option to disable skyboxes through mapinfo
Squashed commit of the following:
commit d4c4d9310d0157ce575f52989b5b080398cf7629
Author: Marisa Kirisame <marisa@sayachan.org>
Date: Wed Dec 30 09:58:39 2020 +0100
Disable AO for skybox portals (can be forced back with MAPINFO flag).
